Adjusting The Door; Three Wire Connection - Gaggenau BS 470 6 Serie Instructions D'installation

Adjusting the door

For precise alignment, the appliance door can be easily
adjusted.
For this purpose, slightly pull out the appliance from the
built-in cut-out. At the top of the appliance there is an
oval opening located on the hinge side. Remove the
cover cap. Slightly loosen both screws (Inbus 5 mm),
but do not remove them!
Align the door via the lateral screw (Torx 20).
All manuals and user guides at all-guides.com
Tighten both screws (Inbus 5 mm) again. Attach the
cover cap again.
Notes
‒
‒
‒

Three wire connection

BO 450/451-610
1
2
3
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
The alignment of the appliance door can be
adjusted via the upper hinge, in order to achieve a
precise gap size of the top edge of the door to the
upper air output.
The height of the door cannot be adjusted.
The device door is already aligned when the
appliance is delivered. You do not normally need to
align the door.
Connect red wire from oven to red electrical supply
wire (hot wire).
Connect black wire from oven to black electrical
supply wire (hot wire).
Connect yellow/green ground oven wire to bare
ground electrical supply wire.
11