Set Fan Operation Switch - Honeywell Home RTH2300 Serie Manuel Du Propriétaire

8 Set fan operation switch

Move the switch to the proper setting:
Gas or Oil: For gas or oil heating systems, leave
the fan operation switch in this factory-set
position (for systems that control the fan in a
call for heat).
Electric or Heat Pump: Change the switch
to this setting for heat pump or electric heat
systems. (This setting is for systems that allow
the thermostat to control the fan in a call
for heat, if a fan wire is connected to the G
terminal.)
9 Install Thermostat
onto Wallplate
Install thermostat onto the wallplate
on the wall.
10 Turn Power Back On
Turn the power back on to
the heating/cooling system.
Circuit breaker box Heating/cooling system
7
RTHXXXX
GAS OR OIL
ELECTRIC OR HEAT PUMP
GAS OR OIL
ELECTRIC OR HEAT PUMP
UP
Not
W
Used
Set
Hold
Run
Fan
Fan
Fan
Heat Off Cool
Auto On
Heat Off Cool Auto On
Heat Off Cool Auto On
or
power switch
M32716
M33784A