Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TAPE GUN HOLDER ASSEMBLY
NOTE: Tape Gun Holder can be attached to
uprights or bin rail.
1.
If attaching to bin rail, no assembly is needed.
Place the back folded lip of the bracket over the bin
rail. Push down to ensure it is set firmly in place.
(See Figure 34)
Figure 34
2. If attaching to uprights, slide tape gun upright
bracket underneath tape gun holder and align the
holes in the bracket to the holes on top of the holder.
Attach with two M5 x 10 mm pan head screws and
two M5 flange nuts using a Phillips screwdriver and
8 mm wrench. (See Figure 35)
Figure 35
3. Align gun holder and upright bracket with uprights
at desired height.
4. Secure to uprights with two M6 x 40 mm hex bolts
and two M6 flange nuts. (See Figure 36)
Figure 36
PAGE 9 OF 27
OPTIONAL ACCESSORIES CONTINUED
1-800-295-5510
uline.com
FAN ASSEMBLY
NOTE: Fan comes with 6" and 10" long bracket.
Choose desired bracket based on application.
1.
Slot 6" or 10" fan mounting bracket between opening
in fan upright mounting bracket. Align holes of each
bracket and attach using two M6 x 12 mm hex bolts
and two M6 flange nuts. (See Figure 37)
Figure 37
Upright Mounting Bracket
Fan Mounting Bracket
2. Align hole on the opposite end of fan mounting
bracket to the hole on the crescent fan bracket.
Attach using M12 x 20 mm hex bolt, M12 washer,
M12 lock washer and M12 hex nut. (See Figure 38)
Figure 38
3. Align fan assembly with uprights at desired height.
4. Secure to uprights with two M6 x 40 mm hex bolts
and two M6 flange nuts. (See Figure 39)
Figure 39
0521 IH-8226
Publicité
Table des Matières
