Cable Management - Uline H-8226 Mode D'emploi

MONITOR ARM ASSEMBLY
1. Line up monitor arm mounting bracket (2) with
uprights at desired height.
2. Secure to uprights with two M6 x 35 mm or M6 x 50 mm
Allen head bolts, two small flat washers and two hex
nuts using an Allen wrench and 10 mm wrench.
(See Figure 17)
Figure 17
Allen
Head Bolts
Small Flat
Washers
ATTACHING MONITOR
NOTE: Make sure monitor has a VESA hole
pattern of 100 x 100 mm or 75 x 75 mm.
(See Figure 18)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
Figure 18
75 x 75 mm or
100 x 100 mm
PAGE 6 OF 27
OPTIONAL ACCESSORIES CONTINUED
1. Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to stop
at desired position. Attach monitor to plate. (See Figure 19)
Figure 19
Allen
Large Flat
Wrench
Use appropriate bolts for monitor.
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn towards "–" if
monitor raises up. Turn towards "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 20)
Figure 20
±180º -85º ~15º
Adjust swivel
with Allen
Wrench

CABLE MANAGEMENT

1. To remove covers, use a Phillips head screwdriver
to unscrew the two screws securing covers to the
monitor arm. This allows user to slide cables through
covers. Once complete, re-secure the covers to the
monitor arm using the Phillips head screws.
(See Figure 21)
Take off covers and put cable in.
Figure 21
Washer
Adjust Tilt with
Allen Wrench
±90º
±180º
Insert screw to lock covers.
0521 IH-8226