Uline H-8226 Mode D'emploi page 2

LEGS AND FRAME ASSEMBLY
NOTE: Tabletops add 1⁄ – 1⁄" depending on
top purchased.
1. Flip legs (1 and 2) upside down. Place adjustable
feet (3) into legs and slide to desired height. Fasten
adjustable feet to legs with two M10 x 65 hex bolts
and two M10 nuts per adjustable foot using a 17 mm
wrench. (See Figure 1)
Figure 1
M10 x 65
Hex Bolt
Leg
2. Turn legs upright and spread apart to accommodate
frame support bars (4). Position frame support bars
so that the larger holes are facing down. Open end
of frame support bars should be positioned on the
center leg (1). Fasten support bars to outside leg (2)
with four M8 x 65 hex bolts per leg using a 13 mm
wrench. (See Figure 2) Repeat for other side.
M8 x 65
Hex Bolts
Center Leg
Figure 2
PAGE 2 OF 27
Adjustable
Feet
M10 Nut
Leg
Frame
Support Bars
ASSEMBLY
3. Place center leg support bar (8) between frame
support bars (4) on top of the center leg. Fasten
center leg support bar to frame support bars and
center leg (1) with eight M8 x 65 hex bolts using a
13 mm wrench. (See Figure 3)
Figure 3
BOTTOM SHELF ASSEMBLY
NOTE: Bottom shelf is a two-piece design. One
end of each piece has a channel to rest shelf on
top of the leg brace on the outside legs. The other
end is flat and will bolt to the center leg's brace.
1. Place the end of each shelf piece with the channel across
the leg brace of the outside legs. Have two people hold
up the end of the shelves that face the center leg (1)
and align the holes on the side of the shelf pieces to
the holes in the center leg brace. Fasten shelf pieces
to center leg brace with three M8 x 65 hex bolts and
three M8 nuts using a 13 mm wrench. (See Figures 4-5)
Figure 4
Outside
Leg Brace
Figure 5
M8 x 65
Hex Bolts
Center Leg Support Bar
M8 x 65
Hex Bolts
Center
Leg Brace
0521 IH-8226