auna IR 160 Mode D'emploi page 39

Note: If the network is not linked in the "Enable" mode, it will automatically
show the choices for you to set up the network.
Date and Time
• Set Date and Time
• Manual Setup: You can manually set the date and time.
• Auto Detect (UTC+00:00) 00:00 means the time difference between
service and local time.
Set Time Format (The 24-hour format is default)
• 12 hour
• 24 hour
Set Date Format (The format of DD/MM/YYYY is default)
• YYYY/MM/DD
• DD/MM/YYYY
• MM/DD/YYYY
Alarm
To set up three alarms (Alarm1, Alarm 2, NAP Alarm) and the Alarm Volume.
• The time of NAP Alarm is from 5 minutes to 120 minutes. After the setup
of the NAP Alarm, it begins to count down the time until the time is
over, then it will ring and switch to the standby mode automatically.
• When alarm rings, it will enter the display of "Standby" automatically.
• You can set up the alarm volume by "Alarm Volume".(Volume 7 is
default)
• If you press any button when alarm rings, the alarm will be closed and
enter the mode of standby with 5-minute SNOOZE.
• To exit the SNOOZE mode, press Standby button.
• Exit after the alarm is set up. The new alarm will then be activated.
• Two alarms will not ring at the same time. (Only after one alarm stops
ringing can another alarm be used).
• Alarm 1: Turn On, Turn Off, Repeat: To set up the Alarm Date
• The choices are: Everyday, Once, Mon, Tue, Wed, Thu, Fri, Sat, Sun
• Time: To set the alarm time
EN
39