Cleaning The Oven Door; Lift-Off Oven Door - GE PCGS910 Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Care and cleaning of the range.
Oven floor
Do hand
Do hand
clean the
clean the
glas s door
glas s door
Do not rub or clean the door gasket—
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
Slot
Hinge lock
Pull hinge locks down to unlock.
Removal position
36
Removable Oven Floor
(Except Dual Fuel Models)
To remove the oven floor for easier
cleaning:
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.

Cleaning the Oven Door

To clean the inside of the door:
Gently wipe off glass inner door with hot,
soapy water and a sponge or soft cloth.
Never use fiber, abrasive cleaners or
ammonia based products.
To clean the outside of the door:
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to
clean the glass on the outside of the door.
Do not let water drip into the vent openings.

Lift-Off Oven Door

The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small
flat-blade screwdriver, may be
required.
Firmly grasp both sides of the door
at the top.
Close door to the door removal
position, which is halfway between
the broil stop position and fully
closed.
Lift door up and out until the hinge
arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
Clean the oven floor with warm
soapy water.
IMPORTANT: Always replace the
removable floor before the next use.
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing
acids may cause discoloration and should
be wiped up immediately. When surface is
cool, clean and rinse.
Do not use oven cleaners, cleaning powders
or harsh abrasives on the outside of the door
Bottom
With the
edge
door at the
of slot
same angle as
the removal
position, seat the
indentation of
the hinge arm
into the bottom
edge of the hinge
slot. The notch in the hinge arm
must be fully seated into the bottom
of the slot.
Fully open the door. If the door will
not fully open, the indentation is
not seated correctly in the bottom
edge of the slot.
Push the hinge locks up against the
front frame of the oven cavity to the
locked position.
Hinge
arm
Hinge lock
Push hinge locks up to lock.
Close the oven door.
Hinge arm
Indentation

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pc2s910

Table des Matières