Troubleshooting - HoMedics Deluxe Wrist Manuel D'instructions

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
SYMPTOMS
Unit does not turn on
when the START/STOP
button is pushed.
EE measurement error
symbol shown on dis-
play or the blood pres-
sure value is displayed
excessively low
(or high).
E1 error symbol shown
on display
E2 error symbol shown
on display
E3 error symbol shown
on display
E4 error symbol shown
on display
EP error symbol shown
on display
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
POSSIBLE
CAUSES
Batteries have
run down.
Battery polarities have
been positioned incor-
rectly.
Cuff has been placed
incorrectly.
Did you talk or
move during
measurement?
Shaking of the wrist with
the cuff on.
Air circuit
abnormality.
Inflation pressure exceed-
ing 300 mmHg.
Error determining mea-
surement data.
Component malfunction. Measure again.
System error.
32
CORRECTION
Replace them
with two new AAA LR03
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff properly so
that it is positioned correctly.
Measure again.
Keep wrist steady during
measurement. Measure
again.
Measure again.
Switch the unit off, then
measure again.
Measure again.
Measure again.