Troubleshooting - HoMedics DELUXE ARM Mode D'emploi

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
SYMPTOMS
Unit does not turn on when
the START/STOP button
is pushed.
EE measurement error
symbol shown on display or
the blood pressure value is
displayed excessively low
(or high).
E1 error symbol shown
on display.
E2 error symbol shown
on display.
E3 error symbol shown
on display.
EP error symbol shown
on display.
Note: If the unit still does not work, contact HoMedics Consumer Relations. Under
no circumstance should you disassemble or attempt to repair the unit by yourself.
Contact information for HoMedics Consumer Relations Department can be found in
the Warranty section.
POSSIBLE
CAUSES
Batteries have run down.
Battery polarities have been
positioned incorrectly.
Cuff has been
placed incorrectly.
Did you talk or move
during measurement?
Shaking of the arm with the
cuff on.
Air circuit abnormality. Cuff
tube may not be plugged into
monitor correctly.
Inflation pressure exceeding
300 mmHg.
Error determining
measurement data.
System error.
29
CORRECTION
Replace them with
four new AA
alkaline batteries.
Reinsert the batteries in the
correct positions.
Wrap the cuff properly so that
it is positioned correctly.
Keep arm steady during
measurement.
Measure again.
Check cuff connection.
Measure again.
Switch the unit off, then
measure again.
Rewrap the cuff properly so
that it is positioned correctly.
Take new measurement.
Measure again.