Spinning The Wheel - Accu-Turn 1400 Manuel De L'opérateur

Table des Matières

Publicité

42
All manuals and user guides at all-guides.com
Operations
"S - 2" will appear on the right display. Rotate in the
opposite direction until you find the radial where the
above mentioned index appears.
Note:
Press button "F".
An unbalance less than the initial one appears on the
display on the right hand side.
Rotate and block the wheel in the right plane WAP posi-
tion.
Arrange the indicated weight in the arm applicator.
Move the detector arm to point 0 (zero) of counterweight
application, indicated by the display.
Rotate the arm towards the rim and apply the adhesive
weight.
Rotate and block the wheel in the second WAP position
of the same plane.
Repeat the fastening operation as indicated above for
the first weight.
When finished, perform a check spin.
5.3.3
The wheel type and dimensions must have been en-
tered.
• Pull the tilting hold frame down to its horizontal
position.The motor will start automatically, the wheel
will spin.
The measurement is completed as soon as the direc-
tion indicators light up. The unit will beep. The brake
will be applied automatically.
The weight(s) to be applied will be shown on the dis-
play. For maximum precision, select Fine.
• Raise the tilting frame to its vertical position.
Operator's Manual
The field where "S – 2" appears on the dis-
play is wider than radial width, therefore make
sure the radial is positioned exactly at 12
o'clock before pressing "F" again.

Spinning the wheel.

ACCU 1420

Publicité

Table des Matières
loading

Table des Matières