Belt Adjustment - PowerPeak FTM6715 Mode D'emploi

Cycle switch order is: manual, time, distance, calories.

BELT ADJUSTMENT

You may need to adjust the running belt during the first few weeks of use. All running belts are
properly set at the factory. It may stretch or be off centre after use. Stretching is normal during the
break-in period.
Adjusting the belt tension
If the running belt feels as though it is slipping or hesitating when you place your foot on it during a
run, the tension on the running belt may have to be increased. To increase the running belt tension:
5. Start the treadmill without anyone on the running belt, press SPEED+ button until speed reaches
between 5 and 6 km/h.
6. Place a wrench on the left adjustment screw. Turn the wrench clockwise 1/4 turn to draw the
rear roller and increase the belt tension.
7. Repeat step 2 for the right adjustment screw. You must be sure to turn both bolts the same
number of turns, so the rear roller will remain square relative to the frame.
8. Repeat step 2 and step 3 until the slipping is eliminated.
Note: be careful not to tighten the running belt tension too much as you can create excessive
pressure on the front and rear roller bearings. An excessively tightened running belt may damage
the roller bearings resulting in bearing noise from the front and rear rollers.
Centering the running belt
When you run, you may place more pressure on the belt with one foot than with another. The
severity of this deflection depends on the amount of force that one foot exerts in relation to the
other. This deflection can cause the belt to move off-centre. This deflection is normal and the
running belt will centre when nobody is on the running belt.
If the running belt remains consistently off-centre, you will need to centre the running belt manually:
5. Place the device on a level surface.
6. Start the treadmill without anyone on the running belt, press SPEED+ button until speed reaches
5,6 km/h.
7. Observe whether the running belt is toward the right or left side of the deck.
a. If toward the left side of the deck:
Turn the left adjustment screw clockwise 1/2 turn, and the right adjustment bolt
counter clockwise 1/2 turn.
b. If toward the right side of the deck:
Turn the right adjustment screw clockwise 1/2 turn, and the left adjustment bolt
counter clockwise 1/2 turn.
PI
PI
45