Mmx 300 Headset - Beyerdynamic Headzone Game Notice D'utilisation

7.

MMX 300 Headset

Connection
• The MMX 300 headset provides two mini jack plugs
(3.5 mm). Connect the headphone cable to the HBC 1
base station and the microphone cable to the
microphone input of your PC or game console. Refer
also to chapter 5.1 "How to connect the HBC 1 base
station".
Important: When connecting the headset please
ensure that the volume is turned down to minimum
(i.e. turn the multifunction control
Setting up and use of the headset
• Put the headset on your head. The microphone is on
the left side. Position the microphone to the side of
the mouth. In order to avoid pop noise you should use
the microphone with a pop shield.
• For best comfort and noise attenuation, the headband
has to be adjusted to fit your head properly.
Wear the headset so that the headband runs over the
top of your head and adjust the headband so that
– your ears are completely enclosed by the ear cushions,
– you feel a gentle pressure around your ears,
– both ends of the headband have the same length t
• Turn the microphone holder (not the gooseneck!) to
position the microphone on the left or right hand side
of the mouth.
• Place the wind shield onto the microphone and make
sure that the microphone is completely enclosed.
• Bend the flexible gooseneck so that the microphone is
placed about 2 cm in front of the middle of your
mouth.
Important: In order to avoid overstretching and
premature wear and tear never bend the gooseneck
more than 90°.
to the very left).
- 35 -