AEG B 890905 Notice D'utilisation page 25

All manuals and user guides at all-guides.com
Problem
The oven does not heat up
The oven lamp does not oper-
ate.
The oven lamp does not oper-
ate.
It takes too long to finish the
dishes or they are cooked too
fast
Steam and condensation settle
on the food and in the oven
cavity
The display shows an error
message (for example "F....")
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The "Demo" function is acci-
dentally activated (symbol
appears on the display)
The oven lamp is defective
The oven cooking function is
not set.
Incorrect settings
Dishes have been left in the
oven for too long
Electronic fault
What to do if...
Solution
1. In the Off position touch
for about 5 seconds.
The oven turns to stand by
and then off again. An au-
dible signal sounds.
2. Within 5 seconds touch
and at the same
time. Hold them touched
until an audible signal
sounds. The operation is
successful if
disappears when you
switch on the oven again.
Replace the oven lamp.
Touch to switch on the
oven and set the oven cooking
function.
Refer to the cooking function
sections and to any cooking
chart provided.
Do not leave the dishes stand-
ing in the oven for longer than
15-20 minutes after the cook-
ing process ends
Switch the appliance off and on
again through the fuse or the
safety switch in the fuse box. If
the display shows the error
message again, contact the au-
thorised Service Centre.
.........................................
.........................................
.........................................
25
symbol