Replacing The Oven Light Bulb/Cleaning The Glass Cover; What To Do If - AEG B 890905 Notice D'utilisation

24

What to do if...

2. Carefully pull the heating element down.
At this time you can clean the oven ceiling.
Clean the oven ceiling with a soft cloth with
warm water and cleaning agent and let it dry.
Installing the heating element
1. Install the heating element in opposite
sequence.
WARNING!
Make sure that the heating element is cor-
rectly installed and it does not fall down.

Replacing the oven light bulb/cleaning the glass cover

WARNING!
Be careful! There is the risk of electrical shock!
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C heat-resistant oven light bulb. New
oven light bulb must have the same parameters as your previous one.
4. Install the glass cover.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not operate
The oven does not operate
The oven does not operate
The oven does not operate
All manuals and user guides at all-guides.com
The appliance is not correctly
connected or/and the mains
supply to the oven is not on
The oven is switched off.
The clock is not set
The fuse in the fuse box is re-
leased
Possible cause Solution
Check if the appliance is cor-
rectly connected and the mains
supply to the oven is on.
Touch to switch on the
oven.
Set the clock. Refer to "Setting
the clock".
Check the fuse. If the fuse is re-
leased more than one time,
contact a qualified electrician.