Sharp SWA3052DS Manuel D'utilisation page 28

TROUBLESHOOTING
PROBLEM
Other F_ Error appears in the
display window.
The oven display does not
illuminate.
Cooling fan continues to run
after oven is turned off.
Oven door is locked and will
not release, even after cooling.
Oven is not heating.
Oven is not cooking evenly
Oven light is not working
properly.
Oven light stays on.
Cannot remove lens cover on
light.
Oven will not Self- Clean
properly.
Clock and timer are not
working properly.
Excessive moisture
Porcelain chips
SHARP ELECTRONICS CORPORATION • 100 Paragon Drive • Montvale, New Jersey 07645 • USA
SHARP ELECTRONICS OF CANADA LTD • 335 Britannia Road East • Mississauga, Ontario • L4Z 1W9 • Canada
E
POSSIBLE CAUSE
Turn off power at the main power supply (fuse or breaker box), wait a
few seconds and turn it back on again. If condition persists, note the code
number and call an authorized service center.
Turn off power at the main power supply (fuse or breaker box). Turn
breaker back on. If condition persists, call an authorized service center.
The oven components The fan turns off automatically when the electronic components have
have not cooled cooled sufficiently.
sufficiently.
Turn the oven off at the circuit breaker and wait a few seconds. Turn
breaker back on. The oven should reset itself and will be operable.
No power going to Turn on power at the main power supply (fuse or circuit breaker box). If
the oven. condition persists, call a qualified electrician.
Oven Mode or Press cooking option on keypad to select the oven mode and temperature.
Temperature not
selected.
Oven rack is not in Refer to cook charts starting on page 18 for recommended rack position.
correct position.
Convection Bake Always reduce recipe temperature by 25°F (15 °C) when baking with
Mode Convection Bake mode.
Light bulb is loose or Replace or reinsert the light bulb if loose or defective. Touching the bulb
burned out. with fingers may cause the bulb to burn out.
Oven door does not Check for obstruction in oven door. Check to see if hinge is bent or door
close completely. switch is broken.
Lens cover is dirty. There may be a soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Oven was still warm Allow the oven to cool before running Self-Cleaning.
when Cleaning mode
was selected.
Oven is heavily Always wipe out loose soils or heavy spillover before running Self-
soiled. Cleaning. See OVEN FINISHES/CLEAN METHODS on page 24
If oven is badly soiled, set oven for a 4-hour Self-Cleaning.
No power going to Turn on power at the main power supply persists, call an authorized
the oven. service center.
Clock or Timer not See Timer on page 10 and Clock on page 11
set correctly.
Oven was not When using bake mode, preheat the oven first. Convection Bake and
properly preheated. Convection Roast will eliminate any moisture in oven (one of the advan-
tages of convection).
Oven racks removed When oven racks are removed and replaced, always tilt racks upward and
and replaced do not force them to avoid chipping the porcelain.
incorrectly.
SOLUTION
28