Oven Door Removal; Important - Sharp SWA3052DS Manuel D'utilisation

• When the oven heat drops to a safe temperature, the automatic
door lock will release and the door can be opened.
• The oven light does not operate during Clean mode.
BEFORE SELF-CLEANING
1 Remove all utensils and bakeware.
2 Remove non-porcelain oven racks. If chromed racks are left
in the oven during the self-clean cycle, they will permanently
lose the shiny finish and change to a dull dark finish. See
"Oven Finishes/Cleaning Methods" for proper care on
page 24.
3 Wipe up any soft soil spills and grease with paper towels.
Excess grease will cause flames and smoke inside the oven
during self-cleaning.
4 Be sure oven interior lights are turned off and the light bulbs
and lens covers are in place.
5 Some areas of the oven such as the oven door edge, oven door
window, oven front frame and up to 1
frame do not get hot enough during the cleaning cycle for
soil to burn away and must be cleaned by hand. BEFORE
the cycle begins, clean oven interior using a soapy sponge
or plastic scrubber and a solution of detergent and hot water.
Rinse and dry all areas thoroughly.
NOTE: Do not rub the oven door gasket.
Hand clean
frame area
out side
gasket
DO NOT
hand clean
gasket
Hand clean
door area
out side
gasket
SELF-CLEAN CYCLE
A minimum 24-hour wait is recommended between cleaning
cycles.
TO SELF-CLEAN:
1 Close the oven door.
2 Press SELF CLEAN. "REMOVE RACKS" will appear in
the selected oven text area of the display.
3 "2:00 3:00 3:30" will appear in the display.
4 Use the number keypad to select the clean level. Select 1-3.
5 If you want to delay the start of the self-cleaning cycle, press
START TIME, and then set a time, by pressing the number
keypad.
6 Press START.
/ " (2-3 cm) inside the
1
2
Hand clean 1"
(2 cm) from
rack guides to
front of oven
cavity
Hand clean
door window
25
After the door is locked, "SELF CLEAN" will scroll in the
selected text area until the clean cycle is finished. When the
Self-clean Cycle Ends: "COMPLETE" appears in the display
and the oven door unlocks.
NOTE: SELF CLEAN can be canceled by pressing STOP/
CLEAR. The oven door will remain locked if the oven cavity
is above a safe temperature and will unlock when the oven
cavity has cooled.
7 Once the oven has completely cooled, remove ash with a
damp cloth.
NOTE: To avoid breaking the glass, do not apply a cool, damp
cloth to the inner door glass before it has cooled completely.

OVEN DOOR REMOVAL

For normal oven use, there is no need to remove the oven door.
However, should it become necessary to remove the door, follow
the instructions in this section.

IMPORTANT:

• Make sure oven is cool and that power to the oven has been
turned off before removing the door.
• The oven door is heavy and fragile, and the door front is
glass. To avoid oven door glass breakage, use both hands,
and grasp only the sides of the oven door to remove. Do not
grasp the handle.
• Be sure both levers are securely in place before removing
the door.
• Do not force door open or closed.
TO REMOVE THE OVEN DOOR:
1 Open the door completely.
2 Flip up the hinge latch on each side.
A
A - Hinge Bracket
3 Holding the door firmly, close the oven door completely.
4 Grasping both sides lift up on the oven door while pushing it
closed, and then pull it away from the door frame.
5 Place the door in a protected location.
OVEN CARE
A
E