Bestway FLOWCLEAR 58404 Manuel Du Propriétaire page 5

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to
ensure nothing is damaged. If equipment is damaged,immediately
notify the retailer from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and Control Valve
are accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically
fixed on ground or a certain pedestal made of wood or concrete
before use to prevent the sand filter from accideutally falling. Fully assembled sand filter will
exceed 18kg. The mounting holes should be 8mm in diameter and spaced 110mm apart. Use
two bolts and nuts with a maximum of 8mm in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 25kg bag should suffice. If you do not use the recommended size filter
sand, filtering performance will be reduced and the sand filter may damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank
to submerse the Skimmer on the Collector Hub.
NOTE: SAND NOT INCLUDED.
Connect to the pool
1
S-S-005011/21.0x28.5cm/58404GS / 1500gal 德规砂滤器说明书/JS-YF-2016-B-08880-英
C
C
A
B
A
A
B B
MAX
MIN
C
A
B
5
110mm
C
Ø8mm
S-S-005011