Table des Matières
Publicité
27
model no. 052-0052-2 | contact us 1-800-689-9928
MEASURING FREQUENCY
1.
Connect the black test lead to the "COM" terminal and the red
test lead to the "INPUT" terminal.
2.
Set the function switch to Hz/% position. Then press the "Hz %"
button until the display shows "Hz".
3.
Connect the test leads across the source or circuit to be tested.
4.
Read the reading on the display.
NOTE:
1.
For frequency measurements, the range exchange is automatic,
and measurement range is: 0 – 10 MHz.
2.
The voltage of input signal should be between 1 and 20 V RMS.
The higher the frequency, the higher the required input voltage.
3.
For measurements < 10 Hz, the amplitude of input signal must
be more than 2 V RMS.
All manuals and user guides at all-guides.com
Publicité
Table des Matières
