Table des Matières
Publicité
19
model no. 052-0052-2 | contact us 1-800-689-9928
2.
When you perform a new measurement, the display shows the
difference between the reference and the new measurement.
3.
To exit Relative mode, just press the "REL" button again. The
symbol "REL" disappears.
NOTE:
When in Relative mode, the actual value of the object under test must
not exceed the full-scale value of the selected range. Use a higher
measurement range if necessary.
DATA HOLD MODE
Press the HOLD button to hold the present reading on the display.
"
" appears on the display as an indicator. To exit Data Hold mode,
just press this button again. "
MANUAL RANGING AND AUTORANGING
The meter defaults to autorange mode in measurement functions
which have both autorange mode and manual range mode. When the
meter is in autorange mode, the symbol "AUTO" is displayed.
1.
Press the RANGE button. The meter enters manual range mode
and the symbol "AUTO" disappears.
Each press of the RANGE button increases the range. After the
highest range, the meter wraps to the lowest range.
2.
To exit manual range mode, press and hold down the RANGE
button for more than about 2 seconds. The meter returns to
autorange mode and "AUTO" is displayed.
All manuals and user guides at all-guides.com
" disappears.
Publicité
Table des Matières
