Pump Wiring Instructions - Zoeller 600 Serie Manuel Du Propriétaire

Table des Matières

Les langues disponibles

Installation and checking of electrical circuits and hardware should be performed by a qualified licensed electrician.

"Risk of electrical shock" Do not remove power supply cord and strain relief or connect conduit directly to the pump.

Power cords, sensor cords, and float cords all must be sealed to prevent gases from the basin entering the control panel.

CAUTION

It is very important that these units be connected for proper rotation. Since no rotating parts are visible without removing the pump from the pit,

the rotation on 3 phase units should be checked before installation into the pit as follows:

After the proper electrical connections are made, momentarily energize the pump observing the direction of kick back due to starting torque. The rotation is

correct if the kick back is in the opposite direction of the rotation arrow. If the rotation is not correct, disconnect power and switch any two power leads. Turn

power back on and retest for proper rotation.

(1) Double seal pumps offer extra motion protection from damage caused by seal failure.

(2) Pumps should be serviced on a periodic preventative maintenance schedule.

(3) Oil in the motor housing and lower seal cavity must be checked when pump is serviced. If oil from the motor housing contains water or other contamina-

tions, both seals should be replaced during maintenance. Always replace with new factory recommended oil and service parts. All warranty repairs must

be made by Zoeller Authorized Service Stations.

These pumps are nonautomatic. They require a control panel. A motor starter circuit, control circuit, and alarm circuit within the panel are standard features. Out-

door enclosures and alternating relays are often required. Variable level float switches are the most common level sensing device. The following should be noted.

(1) Single phase units have externally mounted capacitors and starting relays. Your control panel should have provisions for mounting these starting compo-

nents.

(2) All pumps require overload protection in panel. Use with approved motor control that matches motor input in full load amperes with overload element(s)

selected or adjusted in accordance with control instructions.

(3) Hazardous Location pumps require panels that offer intrinsically safe relays and all other NEC requirements must be followed (see Article 500, 501 & 502

plus any others that apply.)

Three phase pumps are nonautomatic. To operate automatically, a control panel

is required. Follow the instructions provided with the panel to wire the system.

Before installing a pump, check the pump rotation to insure that wiring has been

connected properly to power source, and that the green lead of power cord (See

wiring diagram), is connected to a valid ground, Momentarily energize the pump,

observing the directions of kick back due to starting torque. Rotation is correct

if kick back is in the opposite direction of rotation arrow on the pump casing.

If rotation is not correct, switching of any two power leads other than ground,

should provide the proper rotation.

TYPICAL WIRING DIAGRAM

"ON"

FLOAT SWITCH

"OFF"

FLOAT SWITCH

NOTE - FOR 460 VOLT

3 PHASE A CONTROL

CIRCUIT TRANSFORMER

IS REQUIRED

The above wiring diagram shows a typical hookup for a 230 volt, 3 phase pump,

two variable level float switches, and a magnetic starter. It is not intended that

this diagram cover all applications. See wiring diagram supplied with specific

electrical controllers and panels.