Kawasaki K-SMS 1800-250 DB-BD Traduction De La Notice Originale page 31

All manuals and user guides at all-guides.com
• Do not try to slow down the rotating saw blade
by hand.
• Fasten the machine down to a stable base
before use.
• The saw head must be able to move freely and
return to its upper starting position after it is
released.
• Do not jam the on/off switch in position.
• When doing work that generates dust wear a
breathing mask and protective goggles do not
smoke and avoid naked flame.
• Do not use the saw to cut other than aluminum,
wood similar materials.
• Select saw blades in relation to the maternal to
be cut.
• Ensure that the lighting is adequate.
• Do not use the saw unless the guards are in
place.
• Do not use the saw to cut metal or masonry.
• Keep the area free of tripping hazards.
• Do not let anyone under 18 years operate this
saw.
• Always stand to one side when operating the
saw.
• Never use damaged or deformed saw blades.
Only use sharp blades.
• Do not use this saw to cut firewood.
• When cutting round wood, use clamps to
prevent the workpiece from turning on both
sides of the blade.
• Never use your hands to remove sawdust, chips
or waste close by the saw blade.
• Use only blades as recommended by the
manufacturer.
• Do not use blades manufactured from high
speed steel.
• If the table insert is damaged or worn, have it
replaced by an authorized service centre.
• Before making compound mitre cuts, ensure
that the work head is securely fixed in the desired
position.
• Rags, cloths, cord, string and the like should
never be left around the work area.
• Avoid cutting nails. Inspect the workpiece and
remove all nails and other foreign objects
before starting sawing.
• Support the work properly.
• Never reach over the blade to remove waste or
off cuts.
• Do not attempt to free a jammed blade before
first switching off the saw.
• Do not slow or stop a blade with a piece of
wood. Let the blade come to rest naturally.
• If you are interrupted when operating the saw,
complete the process and switch off before
looking up.
• Periodically check that all nuts, bolts and other
fixings are properly tightened.
• Always hold the saw on parts that are insulated.
If you accidentally cut into hidden wiring or
the saw's own cable, the metal parts of the saw
will become 'live' . Switch off at the mains and
remove the plug immediately.
• Connect the saw to a dust collection device and
ensure that it is operated properly.
• Wear gloves when handling saw blades.
• Keep the floor area around the machine level,
well maintained and free of loose materials such
as wood chips and cut-offs.
• During slide cutting, always ensure that the saw
blade is pushed away from the operator.
• Always use stands to provide support for long
work pieces that overhang the turntable.
• Feed work into a blade or cutter against the
31
GB