Use; Control Board - Franke FKU 908-H TC Mode D'emploi Et Installation

USE

A B
C
Key Function
A Switches the extractor motor on and off at the latest
selected speed
B Decreases the suction speed.
C Increases the suction speed.
D By pressing this key it is possible to start the inten-
sive speed from any previously selected speed ex-
cept the Delay-function and 24H-function. This
speed has been timed at 10 minutes. After that time
the system activates automatically the latest selected
speed. This function is suitable for cooking condi-
tions when vapours and smells are at the utmost e-
mission.
E By pressing this key it is possible to set up the motor
to a suction speed at 100 m
F By pressing this key it is possible to set the delayed
shutdown of the motor and the lighting to 30 min-
utes. This function is suitable for a complete elimi-
nation of residual cooking odours. Functioning only
when the motor is on(not during the 24H-function or
intensive function). By pressing the key the function
is stopped
G By pressing this key for about 2 seconds it is possi-
ble to reset the filter saturation alarm
H By pressing this key the intensity of the lighting
system can be decreased.
I Switches on/off the lighting system at the maximum
intensity.
L By pressing this key the intensity of the lighting
system can be increased.
Keyboard lock: it is possible to jam the keyboard when, for example, cleaning the glass. The
motor and lights are switched off.
By pressing the F-key (Delay) for about 5 seconds the keyboard block can be activated or de-
activated. This function is confirmed by a Beep and by moving motor LEDS on display.
EN
E
D

Control board

3
/h .
F
G
Display
Indicates the selected speed.
The number of lit LEDS decreases.
The number of lit LEDS increases.
I flashes and the LEDS are all lit.
By pressing the key the function is
stopped.
24 appears and the LEDS extinguish one
by one.
By pressing the key the function is
stopped
A flashing clock-symbol appears.
By pressing the key the function is
stopped
After 100 working hours a drop-symbol
appears. Metal grease filters have to be
washed.
After 200 working hours C appears.
Charcoal filters have to replaced.
L
I
H
1
12
2