Holmatro EHW 1650 RC Mode D'emploi page 21

1 Introduction
English
1.1 Disclaimer
All rights reserved. Nothing from this publication may be disclosed, reproduced or modified in any way
without prior written consent from Holmatro. Holmatro reserves the right to modify or alter parts of tools
without prior notification. The contents of this user manual can likewise be modified at all times. This
user manual is based on and is related to the models manufactured at this moment and legislation
currently in place. Holmatro accepts no liability whatsoever for possible damage resulting from the use
of this user manual with respect to any equipment supplied or possibly to be supplied, subject to intent
or gross negligence on the part of Holmatro. For detailed information about the use of the user manual,
maintenance and/or repair of Holmatro equipment, Holmatro or the official, appointed distributor must
be contacted. All possible attention has been given to the composition and precision of this user
manual. However, Holmatro cannot be held liable for errors and omissions or obligations issuing from
them. If the correctness or completeness of this user manual is unclear, you must contact Holmatro.
1.2 About this manual
The original instructions in this manual are written in English. Other language versions of this manual
are a translation of the original instructions.
1.3 Definitions
/i
System:
Pump:
Hose:
Tool:
Equipment:
1.4 General
Congratulations on your purchase of this Holmatro product. This user manual provides instructions on
the operation, maintenance, malfunctions and safety of the equipment concerned. Safety regulations for
the use of a complete Holmatro system are also described in this user manual. Illustrations in this user
manual can differ slightly, depending on the model.
Everyone involved in putting the equipment into operation, using it, maintaining it and solving
malfunctions must have read and understood this user manual, particularly the safety regulations.
To prevent errors of operation and ensure that the equipment works trouble-free, the user manuals must
always be available to the operator.
1.5 Application
This product is part of the equipment intended for use in industrial applications, basically to provide
power for hydraulic tools.
1.5.1 System requirements
Because of the diversity in control, operating pressure and required oil volume per tool, not all
combinations of Holmatro pumps, hoses and tools can be applied. In case of doubt about the
compatibility of the system, always consult the Holmatro dealer.
EHW
All manuals and user guides at all-guides.com
the assembly of pump, hose(s) and tool(s).
device that supplies hydraulic flow and pressure.
an assembly of flexible hydraulic line and couplers.
hydraulic device such as a cutter, spreader, combi tool, ram or cylinder.
tool(s), hose(s), pump or accessories
916.219.569_001
EN
21