Control Panel; Setting Up Your Refrigerator; Before Using Your Refrigerator; Finding A Suitable Location - Insignia NS-RFD21SS9-C Guide De L'utilisateur

Control panel

The control panel is located at the top of the refrigerator and is visible when you open up the doors.
CAUTION:
Temperatures inside each compartment may vary from the temperature you selected, depending on how much food you
store and where you place it. Ambient temperature may also affect the actual temperature inside your refrigerator.
ITEM
NO.
Door Alarm
1
Freezer
2
Fridge
3
Water Filter
4
Turbo Cool
5

Setting up your refrigerator

Before using your refrigerator

• Remove the interior packing.
• Let your refrigerator stand upright for approximately four hours before connecting it to power. This reduces the
possibility of a malfunction in the cooling system from improper handling during transportation.
• Wash the inside with a damp warm cloth soaked in a solution of one quart of lukewarm water to two tablespoons of
baking soda.
• Wait to load the refrigerator with food for approximately two hours after moving your refrigerator or plugging it in for
the first time so that the coolant fluid settles
• For correct operation, you should level your refrigerator using the levelling feet. If you do not level your refrigerator, the
doors may not close or seal correctly, causing cooling, frost, and moisture problems. Turn the levelling feet clockwise to
raise or counterclockwise to lower a side. The levelling feet are easier to adjust if you have someone push against the
top of your refrigerator to take some weight off.
• When moving your refrigerator, do not tilt it beyond 45° from upright.

Finding a suitable location

• Place your refrigerator on a floor that is strong enough to support your refrigerator when it is fully loaded.
• Do not install your refrigerator on carpeting or a rug.
• Your refrigerator is designed to be free standing and should not be recessed or built-in.
• If you use your refrigerator in a garage, make sure that the ambient temperature is between 50°F (10°C) and
109°F (43°C).
• Adjust the feet to keep your refrigerator level.
• If you locate your refrigerator next to a fixed wall, allow sufficient space on the hinge side for the door to swing open.
• Position your refrigerator away from direct sunlight and sources of heat, such as a stove, heater, or radiator. Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent your refrigerator from performing correctly.
• Avoid locating your refrigerator in moist areas.
Your refrigerator is designed to operate in a temperature range of 50°F (10°C) and 109°F (43°C). If you operate your
refrigerator outside this temperature range, your refrigerator may not work correctly.
All manuals and user guides at all-guides.com
DESCRIPTION
Press to turn the door alarm on or off.
Press repeatedly to set the freezer temperature. The default temperature is 0°F
(-17.8°C).
Press repeatedly to set the fridge temperature. The default temperature is 37°F (2.8°C).
Pressing this button does not affect the refrigerator.
Press and hold for three seconds to rapidly cool the refrigerator.
www.insigniaproducts.com
NS-RFD21SS9-C
9