Replacement Of A Lost Remote Control; Adding/Deleting Rts Transmitter - SOMFY Sonesse 50 RTS Notice D'installation

7.3. Replacement of a lost remote control

This reset deletes all transmitters programmed, but
end-limits, intermediate position and sensors are
retained.
Only switch off the current for the motor to be reset!
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 10 to 15
seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the shade moves
during 5 seconds (If the shade position is an end limit,
the behavior of the shade will be a jog).
5) Press the RTS transmitter (B) PROG button until the
shade jogs: all the RTS transmitter are cleared and the
new RTS transmitter is programmed in the motor.

7.4. Adding/deleting RTS transmitter

Find a RTS transmitter programmed in the motor.
Press and hold the programmed RTS transmitter's
(A) PROG button until the shade jogs: the motor is in
programming mode.
Press briefly the RTS transmitter (B) PROG button to
add or delete this transmitter: the shade jogs and the
RTS transmitter is programmed or deleted from the
motor.
10
All manuals and user guides at all-guides.com
© 2013 Somfy SAS. All rights reserved. 12/2013
1
2
2 sec
3 4
2 sec
5
PROG.
B
+
PROG.
A
-
PROG.
A
PROG.
A
C
10 to 15
sec
A
PROG.
B
PROG.
B
C
PROG.
C
C