AEG SCE81826TS Notice D'utilisation page 15

All manuals and user guides at all-guides.com
Problem
Audible or visual alarm is on. The cabinet has been re-
A or symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Possible cause
cently switched on or the
temperature is too high.
The temperature in the ap-
pliance is too high.
The door is left open.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "Frostmatic function"
or "Coolmatic function" is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Appliance is fully loaded
and it is set to the lowest
temperature
ENGLISH
Solution
Refer to "High temperature
alarm".
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Close the door. Refer to "Door
open alarm"
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Frostmatic function"
or "Coolmatic function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Set a higher temperature. Re-
fer to "Operation".
15