Power Setting - ALPATEC RC 20 ET Notice D'utilisation

All manuals and user guides at all-guides.com
notice RC_20ET 16/05/06

POWER SETTING

While the set temperature is higher than indoor temperature, the LCD shows
pattern begins to flick. The heater then works in low-heating mode.
Press the HIGH/LOW button. LCD shows
high-heating speed.
Press the HIGH/LOW button again. LCD shows
working in low-heating speed.
SWING :
Press the « SWING » button once.
LCD shows flicker. The heater starts swinging.
Press the « SWING » button again, the heater stops swinging.
To turn off the heater, press ON/OFF button.
AUTOMATIC CUT-OFF :
This appliance is equipped with an automatic cut-off device in case of overheating or fall.
The appliance restarts automatically when temperature reaches a normal level or when the appliance
is replaced normally.
12:05 Page 13
, the sun pattern flicks, the heater starts working in
, the sun pattern flicks, the heater starts
13
and the « »