SilverCrest SKMP 1200 A2 Mode D'emploi page 60

All manuals and user guides at all-guides.com
RP100104-105590 Küchenmaschine LB2 Seite 58 Donnerstag, 12. Juni 2014 12:25 12
swimming pool, as water may splash
into the appliance.
If liquid should enter the appliance,
unplug the mains plug immediately and
have the appliance repaired by a
qualified technician. The contact data
can be found in "Service Centre" on
page 70.
• Never touch the appliance, the mains
cable or the mains plug with wet hands.
• Always unplug it by pulling out the plug,
never pull on the cable itself.
• Ensure that the mains cable is not kinked,
twisted or crushed.
• Keep the mains cable away from hot
surfaces, such as the top of a stove.
• If you are not going to use the appliance
for a while, remove the plug from the
wall socket. Only then is the appliance
completely free of current.
• Avoid using extension cables. These
may only be used under very specific
conditions:
– the extension cable must be able to
handle the amount of current drawn
by the appliance,
– the extension cable must not be
"suspended". Keep children away
from it and ensure that it does not
present a trip hazard,
– under no circumstances
damaged extension cable,
– do not connect any other appliances
to the mains socket, since it could
cause an overload (do not use
multiple sockets of any kind).
58
4.5 Preventing injury
Warning! To avoid injury, please
observe the following information.
• Make sure that the mains cable never
becomes a trip hazard, that no-one can
get tangled in it or tread on it.
• During operation, avoid contact with the
moving parts of the appliance such as
the blades of the blender jug 12, the
dough hook 13, balloon whisk 14 or
beater 15. Your hands or hair could be
drawn into the appliance, leading to
injuries. Only ever switch the appliance
on if you have correctly fitted the splash
guard 8 when using the mixing bowl 16
or the lid 11 when using the blender
jug 12.
• Always remove the power supply plug
from the mains socket before cleaning
the appliance or changing the attach-
ments.
• Remember that the blades of the blender
jug 12 are extremely sharp. Never
touch the blades with bare fingers to
avoid cutting yourself.
• Always first switch off the appliance
using the speed controller 4 before
removing the power supply plug. Other-
wise the appliance might start up when
use a
you insert the power supply plug in a
mains socket again.
• If you are not using the blender jug 12,
the cover 2 must be fitted. Otherwise the
appliance will not work so as to protect
the user from injury.