Troubleshooting; Disposal - Waeco BordBar AS-25 Notice D'utilisation

_AS-25.book Seite 19 Mittwoch, 4. Juni 2008 11:24 11
8

Troubleshooting

Fault
Your cooler does not work
(plug is inserted).
The cooler does not cool
(plug is inserted).
Operation with a
12 V socket
(cigarette lighter):
The ignition is on and the
cooler is not working.
Pull the plug out of the
socket and make the fol-
lowing checks.
9

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in accord-
ance with the applicable disposal regulations.
All manuals and user guides at all-guides.com
Possible cause
There is no voltage
flowing from the 12 V
socket (cigarette
lighter) in your vehicle.
No voltage present at
the AC voltage socket.
The inner fan or the
cooling element is
defective.
The cigarette lighter
socket is dirty. This
results in a poor elec-
trical contact.
The fuse of the 12 V
plug has blown.
The vehicle fuse has
blown.
Troubleshooting
Suggested remedy
The ignition must be switched on in
most vehicles for voltage to flow at the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an author-
ised customer services unit.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
Replace the fuse (5 A) in the 12 V plug
(3 1, page 3).
Replace the vehicle's 12 V socket fuse
(usually 15 A). (Please refer to the oper-
ating manual of your vehicle.)
19