Ipod Messages; Usb Messages; Resetting The Main Unit - Pioneer HTP-700 Mode D'emploi

Additional information

iPod messages

Symptom Cause
iPod/USB Error 1 There is a problem with the signal path
(I/U ERR1) from the iPod to the system.
iPod/USB Error 2
The software version being used with the
iPod needs to be updated.
(I/U ERR2)
An iPod not supported by this system is
connected.
iPod/USB Error 3 When there is no response from the
iPod.
(I/U ERR3)
No Track
When there are no tracks in the category
selected on the iPod.

USB messages

Symptom Cause
iPod/USB Error 1 There is a problem with the signal path
from the USB to the system.
(I/U ERR1)
iPod/USB Error 3 When there is no response from the
USB.
(I/U ERR3)
iPod/USB Error 4 The power requirements of the USB
device are too high for this system.
(I/U ERR4)

Resetting the main unit

Use this procedure to reset all the system's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the system into standby.
2 While holding down the ST/MONO
button, press and hold the  STANDBY/ON
button for about two seconds.
3 When you see RESET? appear in the
display, press TUNE –.
OK? shows in the display.
All manuals and user guides at all-guides.com
4
OK appears in the display to indicate that the
system has been reset to the factory settings.
Action
Switch off the system and reconnect the
iPod to the system. If this doesn't seem to
work, try resetting your iPod.
Update the software being used with the
iPod (please use the latest iPod software
versions later than the iPod updater 2004-
10-20).
Connect the iPod supported by this
system.
Update the iPod software to the latest
version. If this doesn't seem to work, try
resetting your iPod.
Select a different category.
Action
Switch off the system and reconnect the
USB to the system.
Switch off the system and reconnect the
USB to the system.
Switch off the system and reconnect the
USB to the system.
Press TUNE + to confirm.
10
81
En