Attaching The Speakers - Pioneer HTP-700 Mode D'emploi

Speaker Setup (HTP-FS500)

Attaching the speakers

The front speaker can be hung vertically or
horizontally on the wall. Use one hole to hang
it vertically and two holes to hang it
horizontally.
When installing the speaker horizontally, set it
up so that the speaker terminal on the back
side of the speaker is on the outside on the end
of the surface, farthest away from the other
speaker.
Speaker terminal
Mounting holes
Front right
Additional notes on speaker
placement
• Install the front left and right speakers at
an equal distance from the TV.
Precautions:
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
• The front speakers supplied with this
system are magnetically shielded.
However, depending on the installation
location, color distortion may occur if the
speaker is installed extremely close to the
screen of a television set. If this case
happens, turn the power switch of the
television set OFF, and turn it ON after
15 min. to 30 min. If the problem persists,
place the speaker system away from the
television set.
All manuals and user guides at all-guides.com
For Enhanced Sound Quality
Speaker terminal
A home theater system can be easily
constructed using just the front (right/left)
speakers and the subwoofer of this set, but by
adding optional S-SWR5CR speaker systems,
you can enjoy genuine 5.1 channel surround
Front left
sound.
Take the following points into account when
connecting the optional speaker systems:
• The subwoofer is not magnetically shielded
and so should not be placed near a TV or
monitor. Magnetic storage media (such as
floppy discs and tape or video cassettes)
should also not be kept close to the
subwoofer.
• Do not attach the subwoofer to a wall or
ceiling. They may fall off and cause injury.
• When the contents of these Operating
Instructions from chapter 2 on describe a
specific model, use those portions dealing
with the HTP-600.
• For information regarding the installation
and connection of optional speaker
systems, consult the information provided
with the optional speaker systems,
together Speaker Setup (HTP-600) on
page 18 portion of these Operating
Instructions.
• See Automatically setting up for surround
sound (MCACC) on page 45 to set up your
system again using MCACC.
01
25
En