Installation; Switching The Control Unit On & Off; Quick Start Guide; Operation & Use - Rohde ST 410 Notice D'utilisation

5.

Installation

5.1. Switching the control unit on & off
The rocker switch for switching the control unit on and off is located on the underside of the housing.
Switching the control
unit on
Switching the control
unit off
5.2.

Quick start guide

• Switch on and wait for the kiln temperature display.
• Call up firing programs with the
• Select the firing program with the
• To start the selected program, press the
• To stop the firing at any time, press the
• The firing data and the programming mode can be called up again with the
• Change the firing data and change the displayed value with the
g
• Use the key again as necessary to step to the next firing value or segment to be reviewed or changed.
h
• Use the
key to switch back to the previous value.
• To mark the end of a program, set the ramp rate to END with the
• To exit programming mode, either wait 20 seconds or press the
6. Operation & use
6.1.

Keylock

Unlock keys:
Step Action
1 If any key is pressed and "LOC" appears in the display,
d
2
Press the
3
Hold down the
Lock keys:
Step Action
d
1
Press the
2
Hold down the
Set the rocker switch to position "I".
Set the rocker switch to position "0".
g
key.
f d
or key.
j
key.
j
key again.
f
and keys simultaneously.
d f
and keys for 5 seconds to unlock.
f
and keys simultaneously.
d f
and keys for 5 seconds to lock.
g
f d
or keys.
f
key.
j
key to start firing.
the keys are locked.
50 / 280
key.
Display screen
LOC
ULOC
Display screen
LOC