CLAS EG 0428 Mode D'emploi page 5

EG 0428
OPERATION
1. Move the exhaust gaz extractor to the afterbody of automobile, loosen the slide pole handle,
align the suction nozzle and the exhaust pipe (the pipe must be inside the nozzle).
2. After make sure the nozzle is aligned with exhaust pipe, tighten the handle and put hose on
the ground.
3. Turn on the power switch, system starts working.
DON'T MOVE THE VEHICLE WHEN THE EXTRACTION SYSTEM IS WORKING.
Maintenance
Clean the surface of equipment after daily work to avoid rustiness or premature wear. When not
using, please move the device for tidy.
TROUBLE SHOOTING
Fault
System doesn't work when the
power on
Exhaust in instead of out when the
power on
EXTRACTOR UNIT GAS PORTABLE HGV
1.Voltage is not suitable
2.Motor doesn't work
The power phase wrong, so fan
Possible reason
rotates conversely
Measure
1.Check the voltage is regular or not,
adjust voltage (voltage should be
220V).
2.Check the fan is breakdown or not
Adjust the phase of power