Programming
Remote Control
Below are the steps to program a
new or existing remote control.
Test remote control before
reprogramming.
1. Press and release the LEARN Button
on the garage door opener.
2. Press and hold the button on
the remote control that you
wish to use. Release the button
when the garage door opener
lights blink or two clicks are heard.
For Multi-Function Control Panel 882LMW
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again,
the LED will fl ash once.
3. Press the button on the remote
control that you wish to operate
your garage door.
For Push Button Door Control 883LMW
1. Press and hold the Light button and the
Push button until the Push button LED
begins to blink.
2. Press the button on the remote
control that you wish to operate
your garage door.
If your vehicle is equipped with a
Homelink
®
, you may require an external
adapter depending on the make, model,
and year of your vehicle.
Visit www.homelink.com for additional information.
Wireless Keyless Entry
Refer to the instructions provided with your keyless
entry OR go to LiftMaster.com to download instructions.
Remote Control
LEARN
Button
Garage Door
Opener
OR
LEARN
Button
Control
OR
Push
Button
Light/Learn
Button
Push Button
Door Control
883LMW
To Erase the Memory
Erase ALL Remote Controls and Keyless Entries
Press and hold the LEARN
button until the LED goes out
(approximately 6 seconds).
All remote controls and
keyless entries are now erased.
Erase ALL Devices
(Including myQ enabled accessories)
1. Press and hold the LEARN button until the LED goes
out (approximately 6 seconds).
2. Immediately press and hold the LEARN button until
the LED goes out. All codes are now erased.
Erase the Wi-Fi Network from the Garage Door Opener
Press and hold the adjustment
button until 3 beeps are heard
(approximately 6 seconds).
Erase a myQ Account
Go to myLiftMaster.com to
Door
delete your myQ account.
LEARN
Button
Garage Door
Opener
Adjustment
Button
Garage Door
Opener
7