Uk Trouble Shooting - Homelite i25mhv Manuel D'utilisation

UK TROUBLE SHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORISED SERVICING DEALER.
Problem
Engine will not start:
Engine starts but will not accelerate:
Engine starts but will only run at high speed
at half choke:
Engine does not reach full speed and emits
excessive smoke:
Engine starts, runs, and accelerates but will
not idle:
A
30
All manuals and user guides at all-guides.com
Possible Cause
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder now than when
new.
Carburettor requires adjustment.
Carburettor requires adjustment.
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburettor requires adjustment.
4. Spark arrester screen dirty.
Carburettor requires adjustment.
* Note: The carburettor adjustment needle(s) are equipped with plastic cap(s) that
prevents anticlockwise rotation from the original factory adjustment. If your unit exhibits
specific performance problem(s) where the Trouble Shooting Section recommends a
anticlockwise needle adjustment and no adjustments have been made since original
purchase, the unit should be taken to a factory authorised service centre for repair. In
most cases, the needed adjustment is a simple task for the factory trained service
representative.
B
Solution
1. Check spark. Remove sparking plug.
Reattach the sparking plug cap and lay
sparking plug on metal cylinder. Pull the
starter rope and watch for spark at
sparking plug tip. If there is no spark,
repeat test with a new sparking plug.
2. Push primer bulb until bulb until fuel is
visible in the bulb. If fuel is not apparent,
the primary fuel delivery system is
blocked. Contact a servicing dealer. If
primer bulb fills, engine may be flooded
(see next item).
3. Remove sparking plug, turn blower so
sparking plug hole is aimed at the ground.
Move choke lever to "RUN" and pull starter
cord 10 to 15 times. This will clear excess
fuel from engine. Clean and reinstall
sparking plug. Pull starter three times with
choke lever at "RUN". If engine does not
start, move choke lever to "CHOKE" and
repeat normal starting procedure. If engine
still fails to start, repeat procedure with a
new sparking plug.
4. Contact a servicing dealer.
Contact a servicing dealer.
*Turn mixture needle (A) anticlockwise
1/16 turn.
1. Use fresh fuel and the correct 2-cycle oil mix.
2. Clean per instructions in Maintenance
Section.
3. *Turn mixture needle (A) clockwise
1/16 turn.
4. Contact a servicing dealer.
Turn idle speed screw (B) clockwise to increase
idle speed.