Fitting The Feet; Wall Mounting - SilverCrest SKD 2300 B2 Mode D'emploi

Installation
GB
IE

Fitting the feet

Wall mounting

Fig. drill diagram
12
All manuals and user guides at all-guides.com
CAUTION
► During assembly, lay the appliance on a soft surface, e.g. on a carpet, to
avoid any damage.
♦ Place the appliance on a soft surface with the base uppermost.
♦ Fit the feet 6 to the bottom of the appliance using 2 screws
WARNING
► When drilling the holes ensure that any electric cables or other installations
in the wall, such as water pipes, are not damaged.
► The supplied wall plugs
stone. Before starting the installation, please check your installation location
carefully for its suitability for the anchors. If in doubt, consult a professional.
NOTE
► When selecting the mounting location make sure that a suitable mains wall
socket is located within the plug-in radius of the mains power cord.
► The feet 6 may not be screwed on if the appliance is wall-mounted.
♦ Mark two drill holes at a minimum height of 487 mm and at a distance of
566 mm (see Fig. drill diagram).
♦ Using a drill and an 8 mm drill bit, drill two holes with a minimum depth of
40 mm.
min. 487 mm
♦ Insert the supplied wall plugs
♦ Screw the two wall brackets
are only suitable for mounting in concrete or
37
566 mm
into the holes.
37
to the wall using the supplied screws
34
on each foot.
35
ø 8 mm, 40 mm
.
36
SKD 2300 B2