Setting The Clock; Heating Or Cooling Programs - Bpt TH 125 Mode D'emploi

TH125_ITF 24081800 01_07
After approximately 10 s, or if you press the
button, the display will show the time
P
and room temperature again.
Note. When reset button R is pressed, the
temperature differential returns to the ±0.2
°C default setting.

5 - SETTING THE CLOCK

5.1 - Press the button
The minutes digits flash.
5.2 - Press the button
until the correct minutes value is reached.
Each time the or
the digits on the display go up by one. When
you hold this button down, the digits on the
display increase slowly for the first 5 s then
the sequence of digits advances more quickly.
5.3 - Press button
The hour digits flash.
10
All manuals and user guides at all-guides.com
15-01-2007
20
26
18
24
22
15
P
22 28
6 24
18 R
Fig. 14
(fig. 15).
or (fig. 16) 5.4 - Press the button
until the correct hour is reached.
button is pressed, 5.5 - Press the button
ting procedure (fig. 19).
The colon between the hours and minutes
flashes to confirm the operation is complete.
In any case, if no button is pressed for 10 s,
the unit automatically exits this procedure,
(fig.17).
saving the last data set.
16:23 Pagina 10
18
24
15
22
6
Fig. 15
20
26
18
24
15 22
28
22
6 24
18
Fig. 16
or (fig. 18),
to end the set-
P
R
18
15
6 - HEATING OR COOLING
PROGRAMS
Press the button ( ) (fig. 20) to choose
the cooling ( ) or heating (
The corresponding indication will come on.
In the cooling program, the temperature can
be set from 18 °C to 31 °C.
Over 31 °C, the system goes into shutdown
mode, which is indicated by the message
18
24
15
22
6
18
Fig. 17
20
26
18
24
22
22 28
6 24
18
Fig. 18
) program.