ENGLISH
3) Place a large container right under the spout,
and keep pressing the push lever until no ice is
dispensed.
4) R e m o v e t h e a p r o n p a n e l A . S e e " 3 .
ADJUSTMENT OF ICE PORTION CONTROL".
5) Press the drain switch. The display illuminates
the drain cycle sign when a drain cycle starts,
and illuminates the "end of drain cycle" sign
when the cycle completes. The drain cycle may
not begin immediately after the drain switch is
pressed.
6) Replace the apron panel A in its correct
position. See "3. ADJUSTMENT OF ICE
PORTION CONTROL".
7) Move the power switch, located on the bottom
left of the middle front panel, to the "OFF"
position.
8) When preparing the ice dispenser for long
storage or subfreezing conditions, wipe the
drain pan and grille dry, and unplug the ice
dispenser.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, unplug the
ice dispenser from the electrical supply
network.
2. Ask a trained service person to clean and
sanitize the ice dispenser water system at
least twice a year and to check and clean
the condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or
in a dishwasher.
[1] Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
All manuals and user guides at all-guides.com
[2] Grille, Apron Panel A, Water Pipe, Spout
Wipe these parts with a clean, soft cloth. To
remove the grille, lift it up and pull it toward you. To
remove the apron panel A, turn the two screws on
both sides with a coin, and pull the panel toward
you. Then remove the water pipe by releasing the
clip, and remove the spout by pulling it toward you.
Use a damp cloth containing a neutral cleaner to
wipe off grease or dirt.
Spout
To reinstall the spout, fit the hook into the lower slot
on the apron panel B, then push the tab into the
upper slot.
6
OPEN
Apron Panel A
Pull toward
you
Clip
Spout
Water Pipe
Lift up
Apron Panel B
Grille
Air Filter
Fig. 5
Spout
Hook
Fig. 6
CLOSE
Tab
Upper Slot
Lower Slot
Apron
Panel B