Hoshizaki DCM-60FE Notice D'utilisation page 4

Distributeur de cubelets
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
* A plumbing permit and services of a licensed
plumber may be required in some areas.
* The ice dispenser drain is gravity flow, so ensure
drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
* There should be no backflow in the water circuit.
* Be sure to use the new hose-sets supplied with
the appliance. Do not reuse any old hose-sets.
1) By means of a suitable spanner or wrench,
tighten the 1/2-3/4 nipple (accessory) into the
Rc1/2 fitting at the bottom of the ice dispenser as
indicated. P.T.F.E. tape and/or a suitable sealing
compound should be used to obtain a leak free
joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
2) Attach the angled end of the white flexible inlet
hose (accessory) to free end of 1/2-3/4 nipple
ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide a
leak free joint.
3) Attach the other end of the inlet hose to the
water tap, noting washer is correctly positioned
before hand tightening as above.
4) Attach the grey flexible drain hose (accessory)
to the R3/4 fitting at the bottom of the drain pan,
confirming fitment of rubber washer before finally
hand tightening the joint. P.T.F.E. tape and/or
a suitable sealing compound should be used
to obtain a leak free joint. The pipe can be cut
to length as necessary to suit position of main
drain.
Drain Outlet
R3/4
Fig. 2
All manuals and user guides at all-guides.com
Water Supply
Inlet Rc1/2
1/2-3/4 Nipple
Inlet Hose
Drain Hose
3
Fig. 3
II. OPERATING INSTRUCTIONS
WARNING
1. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the grille in the drain pan clean.
Clean it by using a neutral cleaner and
rinse thoroughly.
2. The use of any electrical equipment
i n v o l v e s t h e o b s e r v a n c e o f s o m e
fundamental rules. In particular:
* Instances of high humidity and moisture
increase the risk of electrical short
circuits and potential electrical shocks. If
in doubt, disconnect the ice dispenser.
* Do not pull the power cord in order to
disconnect the ice dispenser from the
feed network.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the ice dispenser
to prevent damage to the compressor.
5. Periods of 5 to 6 hours without dispensing
ice could result in wet ice or an ice bridge
forming in the storage bin. Always turn off
the ice making switch, and remove ice from
ENGLISH
Water Supply Tap
Inlet Hose

Publicité

Table des Matières
loading

Table des Matières