Installation - Bartscher 200272 Mode D'emploi

3. First, attach the glass supports (1) (2 on the left, 2 on the right, and 2 in front) to the
body of the saladette with glass top. Use the supplied screws (2).
4. Place the left (3) and right (7) glass in the glass supports (1).
5. Using the supplied nuts (8), rubber rings (11) and screws (10) fasten each 2 angle
connectors (9) in the middle of the left (3) and right (7) glass. Place the glass shelf (6)
and fasten by screwing.
6. Using the nuts (8), rubber rings (11) and screws (10) fasten two more angle
connectors (9) at the rear of the left (3) and right (7) glass. Place the rear glass (5)
in the glass supports (1) and fasten the rear glass (5) with the left (3) and right (7)
glass by screwing.
7. Using the nuts (8), rubber rings (11) and screws (10) fasten each 2 angle
connectors (9) at the rear of the glass at the left and right side. Then, place the
upper glass (4) on the right (7), left (3) and rear (5) glass and fasten it to the angle
connectors at right and left side by screwing.
8. Verify if all the glass elements are assembled correctly.

5.2 Installation

Positioning
CAUTION!
Installation and connection of the device may only be performed by certified
specialists.
•
Position the device in safe place of load capacity sufficient for weight of the device
with full content.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric ovens, coal furnaces or other
sources of heat such as direct sunlight. High temperatures may have a negative
effect on cooling power and increase energy consumption.
•
Place the device so as to allow proper air circulation. Keep a minimum distance of
5 cm from the rear, 10 cm at the sides and 30 cm from the ceiling or shelves.
•
Never cover the device's ventilation ducts.
•
Do not place the device where high levels of ambient humidity occur. Such high
humidity may damage the device.
- 32 -