Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Control
Remote
Panel
Control
Button
TIMER
REMOTE CONTROL
•
Before the first use, pull out the battery insulating strip from
the battery compartment to start using the remote control (6).
The battery is included with the product.
•
The remote control can be stored in the handle (9) on the back
of the fan.
•
Replace the battery with the same or equivalent type of
battery.
Replacing the battery
•
Hold the remote control with the back side facing up.
•
On the bottom of the remote control, use your thumb (or a flat
screwdriver) to push and hold the small locking clip towards
the opposite corner of the clip. While still holding, pull the
groove on the battery compartment to slide it out (Fig. 1).
•
Install a new battery (1 x CR2032 3V Lithium button battery)
with the + side facing up and close the battery compartment.
HOW TO USE
Press to set the Auto On or Auto Off
Timer and automatically turn the fan ON
or to STANDBY MODE (stop) at a later
time.
•
Press the button repeatedly to select
the desired time 1,2,4,8 hours. The
indicator light(s) (1H/2H/4H/8H) will
illuminate accordingly.
•
After setting an Auto On Timer when
the fan is in STANDBY MODE (stop),
you can also preset your favorite
SPEED, MODE, LEFT-RIGHT and UP-
DOWN oscillations before the fan
automatically turns on.
Function
EN
11
Publicité
Chapitres
Table des Matières
