Setting The Language - Topcom Butler 2410C Mode D'emploi

Butler 2410C
4 OPERATION

4.1 Setting the language

The telephone has 5 display languages: see display languages table on packaging!!
To set the language, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'LANGUE' appears on the display.
• Press the Programming key
• The language set appears on the display.
• Press the Up or Down key
• Once the desired language appears on the display, press the Programming key
your selection or repeatedly press the Mute/Delete key to leave the menu.
4.2 Subscribing a handset to a Butler 1000, 1010, 1210, 2405, 2410 base unit
In order to be able to make and receive telephone calls, a new handset has to be subscribed to
the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is sub-
scribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Butler 1000, 1010, 1210, 2405,2410 handset
and base unit!!
Keep the Paging key
on the base unit begins to blink rapidly. The Line/Charge indicator
for one minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a
number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit
number. It is best to use '1' .
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds when the handset has found the base unit.
• Press the Programming key
All manuals and user guides at all-guides.com
.
repeatedly until 'SETTING' appears on the display
.
.
repeatedly to select the language you would like to use.
on the base unit pressed for 10 seconds until the Line/Charge indicator
.
repeatedly until 'BASE SUB' appears on the display.
.
appears on the display.
.
7 7 7 7 7 7 7 7 7 7 7
to confirm
will blink rapidly