Salton KM-40 Mode D'emploi page 17

4. Wipe the Mixer Base and Head with a clean, damp cloth.
Dry thoroughly with a soft cloth.
NOTE: DO NOT use harsh detergents or abrasive cleansers on any part
of the appliance. DO NOT immerse the Base or power cord and plug in
water or any other liquid.
HOW TO ASSEMBLE / DISASSEMBLE
IMPORTANT: Before inserting and removing accessories or raising or
lowering the Mixer Head, switch off the mixer and remove the plug from
the electrical outlet.
Assembling the Bowl
To install the Bowl place the bottom of the Bowl on the turntable in the Base.
Turn the Bowl clockwise until it locks into position with a click.
Disassembling the Bowl
To remove the Bowl turn counter-clockwise and lift away from the Base.
Assembling the BeaterWhisks and Dough Hooks
Push the BeaterWhisks and Dough Hooks into the accessory sockets on the
underside of the Mixer Head until they click into place.
NOTE:
1. The BeaterWhisk with the plastic nodules on the base should be in
the socket closest to the front of the machine.
2. Both the BeaterWhisks and Dough Hooks have different left and
right hand parts and must be pushed into the appropriate left and
right hand sockets. Both parts can only be locked in place if they are
in the correct sockets. If only one locks in place, it is in the wrong side.
3. You may need to twist the attachments slightly to engage them in
position prior to pushing them into place.
Disassembling the BeaterWhisks and Dough Hooks
To remove the BeaterWhisks and Dough Hooks hold them loosely with one hand
while pressing the Accessory Release Button. The Accessory Release Button does
not eject the accessories but will allow them to be removed by hand.
NOTE: The Bowl and Accessories can only be removed when the Mixer Head
is raised.
Booklet KM-40 v1.indd 17
4
2005/10/28 14:29:13