VOLTCRAFT CHARGE MANAGER 410 Mode D'emploi page 45

The desired programme is selected with the selection buttons "<" or ">". Five different
programmes are available.
"SET CHARGE"
"SET DISCHARGE" =
"SET CHECK"
"SET CYCLE"
"SET ALIVE"
• "CHA" ("CHARGE") means that the inserted battery is being charged.
• "DIS" ("DISCHARGE") means that the inserted battery will only be discharged. There is
no maintenance charge.
• "CHK" ("CHECK") means that a charge follows the discharge.
• "CYC" ("CYCLE") means that the inserted battery will be first charged, then discharged
and finally recharged.
• "ALV" ("ALIVE") means that the battery must go through several charge and discharge
cycles. The "ALIVE" programme is used for activating new batteries and batteries that
were stored for an extended period of time.
Depending on the programme selected, you may also have to choose the matching charge
current.
Charge current input
SLOT1 PROG CHA
SET I-CHA
Use the arrow buttons to select the charge current first. This is also either assumed by the
button "OK" or automatically after five seconds.
Without any input, the "Charge Manager 410" will set the charge current to 500 mA
automatically.
= Charge
Discharge (no maintenance charge!)
= Discharge -> charge
= Charge -> discharge -> charge
= Charge -> discharge -> charge -> discharge -> charge
500mA
45