Horizon Global 65067 Instructions D'installation page 5

1. Trim or remove lower air dam. See Figure 2 If cutting, recommend drilling
3/8" at corners to maintain radius for appearance. 2021 and later models
require die grinder or similar tool to trim air dam reinforcement
2-5/8"[66.675]
1-1/2" [38.1]
3" [76.2 ]
Figure 2a
3. Feed the coiled end of the pull wire through the bolt rearward
attachment hole in the side of the frame and out the access hole. Attach
carriage bolt and spacer (item 1 & 5) to the pull wire. Pull the pull wire with
fasteners into location through the hole. Leave pull wires attached. Repeat
the same process on the both frame rails.
©2021 HORIZON GLOBAL -
Printed in Mexico
2. Feed the coiled end of the pull wire through the bolt forward attachment
hole in the side of the frame and out the access hole. (Note: driver & passenger
side use opposite hole positions) Attach carriage bolt and spacer (item 1 & 2) to
the pull wire. Pull the pull wire with fasteners into location through the hole.
Leave pull wires attached. Repeat the same process on the both frame rails.
Access hole
Figure 2b Rearward
attachment
4. Tape spacer (item 6) to rearward attachment location. See Figure 5.
Then push all fasteners back into the frame rail leaving the pull wire
attached and sticking out. See Figure 4
Sheet 5 of 18
Coil end of
pull wire
65067NP 01-22-21
Forward
attachment
Rev. F