Horizon Global 65067 Instructions D'installation page 4

Always wear SAFETY GLASSES
when installing hitch
⑥
④
③
④
③
⑤
q
②
①
*Flat washers to
be added as
Forward
needed on the
fasteners
outside of the
frame rail
Figure 1
Tape (item 6)
Access
spacer to outside
hole
of frame rail
⑥
6. Raise the hitch into position, feed the pull wires through the slots/holes on the brackets. Pull the fasteners on the side, back through the frame and bracket for support. Feed conical washer over pull wire,
using the washer to hold the bolt in place remove the pull wires and attach the hex nut. Tighten to hold hitch in place, repeat on all fasteners. Note: if necessary use a screwdriver to prevent the spacer
from spinning. (due to vehicle variation some vehicle have support plates that will prevent spacers from spinning) Repeat the same process on both frame rails.
7. Tighten all 1/2 GR8 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 HORIZON GLOBAL -
Printed in Mexico
Installation Instructions
PART NUMBERS: 65067, CQT65067
Tape on the outside of
the frame rail
Removal of lower air dam or trimming required.
Rear
fasteners
①
Forward
Access
Rear
hole
fasteners
Outside
frame rail
Figure 3
Figure 5
Obtain vehicle owners approval before cutting
Fastener Kit: 65067F
p
Spacer
Kink Pull wire to keep
spacer independent of bolt
Frame rail
Example of pull wire procedure
3''
Forward
fasteners
Sheet 4 of 18
① Qty. (4) Carriage bolt
½-13 x 1.75 GR8
② Qty. (2) Spacer
.250 x 1 x3
③ Qty. (4) Conical washer
½''
④ Qty. (4) Het Nut
½ -13
⑤ Qty. (2) Spacer
¼" x 1.00 x 3.25
Figure 4
⑥ Qty. (2) Spacer (round hole)
3/16 x 1.5 x 2.0
⑦ Qty. (4) Pull wire
½-13
q
Qty. (4) Flat washer
½" *optional
65067N 01-21-21
Lower fascia
Rev. F