Dirt Devil NAVIGATOR M608 Mode D'emploi page 48

5 Use
5.2 Switching between power or silent mode
24
HOUR
18
5.3 Erecting a light fence
19
5.4 Erecting a smart fence
24
HOUR
20
48
All manuals and user guides at all-guides.com
After starting, the robot cleans in power mode.
1. Press the "
2. Press the button again to switch back to
NOTE:
Once you have chosen the power mode,
the suction rate and working speed are
higher than in silent mode and therefore
your robot consumes more electricity.
Proceed as follows to erect a light fence:
1. Set the light fence tower in a place that
2. Switch the light fence tower's power
3. Now power on the robot. It will not pass
1. Erect a light fence as described in
2. Press the "
3. Now power on the robot. Your robot will
NOTE:
To deactivate the smart fence function,
press the "
two short beeps.
" key on the remote control
once to enable silent mode if necessary.
power mode.
your robot will not pass (Fig. 19).
switch to "On".
- The tower's LED is lit and then blinks.
- An invisible light fence is built up.
the fence.
ZChapter 5.3, "Erecting a light fence".
" key on the remote control
to activate smart fence.
- A short beep occurs.
- An invisible smart fence is built up.
completely clean the room it is in. Then it
will pass the light fence to clean the adja-
cent room.
" key again. You will hear