Bosch TES 515 Mode D'emploi page 39

en
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system.
The rinse procedure stops automatically
after about 1 minute.
● Empty the container and clean the milk
tube (6c).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system for cleaning:
● Pull the milk frother (6) forward out of the
appliance.
● Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see figure C at
the start of the operating instructions).
● Clean the individual parts with a detergent
solution and a soft brush. If necessary,
soak in a warm detergent solution.
● Rinse all parts with clear water and dry
them.
● Reassemble all the parts and replace fully
in the appliance.
A Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre­clean the brewing unit automatically:
● Select k by turning the rotary knob (15).
● Place an empty glass under outlet (6a).
● Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
programme, the brewing unit (5a) should
be removed regularly for cleaning. (See
figure E at the start of the operating
instructions.)
● Switch the appliance off at the power on/
off switch O / I (9). No buttons are lit.
● Open the door (5b) to the brewing unit.
● Slide the red lock (5e) on the brewing unit
(5a) completely to the left.
● Press the eject lever (5d) down fully. The
brewing unit is released.
● Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
35
TES515.. | 7/2014