Westfalia 306 224 391 101 07 Instructions De Montage page 18

Installing the electrical kit
1. Disconnect the negative battery terminal.
2. Remove the spare wheel.
3. If necessary, remove the following coverings and panels:
•
In the luggage trunk
Covering of luggage trunk bottom
-
Covering of the rear end plate
-
Covering of the right and left trunk side
-
4. Drill a hole of 40 mm for the cable leadthrough (Fig. 1/4) through the rear end plate on the
left-hand side of the spare wheel well in a suitable flat place.
5. Starting in the luggage trunk, lead the socket end of the cable harness through the cable
leadthrough to the outside and from there to the socket holder plate (Fig. 1/5).
6. Insert the rubber grommet into the cable leadthrough (Fig. 1/4).
Installing the socket
7. Press the contact insert into the socket housing and push the rubber grommet towards the
socket.
8. Screw the socket onto the socket holder plate (Fig. 1/4) using the supplied screws and nuts.
Connecting the tail lights
9. Lay the cable end with the left-side marking to the left-hand tail light.
10. Disconnect the plug-in connector of the left tail light (Fig. 1/1) and connect it to the matching
counterparts on the cable harness. Make sure that the plugs lock firmly into place.
11. Lay the cable end with the right-side marking along the rear end plate to the right-hand tail
light.
12. Disconnect the plug-in connector of the right-hand tail light (Fig. 1/6) and connect it to the
matching counterparts on the cable harness. Make sure that the plugs lock firmly into place.
13. Plug the enclosed relay into the relay socket on the right-hand side. Secure the relay socket
in a suitable way using cable ties.
18
All manuals and user guides at all-guides.com
306 224 391 101 07/04
Installation instructions:
Electrical system for towing hitch
Fiat Stilo