Renkforce 1282378 Notice D'emploi page 43

The remaining control channels come after this first DMX channel (DMX starting address). An address for
a device in a DMX chain can only be assigned once. Ensure that there is a sufficient number of available
DMX channels.
Depending on the DMX operating mode, the light requires 11 or 14 DMX channels.
Setting the DMX operating mode (number of channels)
• Keep pressing the MENU button (4) until "INTRO" appears. Press the ENTER button (3) to confirm.
• Select "CHANNELS" with the DOWN (2) / UP (1) buttons. Confirm your selection with the ENTER button.
• Select "BASIC / ADVANCED" with the DOWN / UP buttons. Confirm your selection with the ENTER button.
• Press the MENU button to exit the menu.
"BASIC" = 11-channel DMX mode
"ADVANCED" = 14-channel DMX mode
Setting the DMX starting address
• Press the MENU button (4) until "INTRO" appears and then confirm with the ENTER button.
• Press the ENTER button to enable the setting of the DMX starting address.
• Use the UP (1) / DOWN (2) buttons to select the desired DMX starting address and confirm your selection
with the ENTER button (3).
The following table provides information on the DMX operating modes and the effects of the settings on
the individual DMX channels.
"BASIC" 11-channel DMX mode
Each of the 11 channels on the moving head is assigned as follows:
DMX DMX value
channel
1 0 -255
2 000 - 255
3 000 - 16
17 - 33
34 - 50
51 - 67
68 - 84
85 - 101
102 - 118
119 - 135
136 - 152
153 - 255
4 Not available
All manuals and user guides at all-guides.com
Function
Rotating movement PAN 0-540°
Swivel movement TILT 0-250°
White brightness
Red brightness
Yellow brightness
Magenta brightness
Green brightness
Orange brightness
Blue brightness
Bright blue brightness
Bright green brightness
Rainbow or linear colour effect
Not available
43